1901B Flush Grid Modular Belt
CSTRANS supplies the 1901B flush grid modular belt for straight carrying sections that need openings through the surface. The modules provide 16% open area around the product-supporting ribs.
- Open Area
- 16%
- Pin Diameter
- 4.6 mm
- Belt Mass
- 6.5 kg/m²
Look at the Contact Points
Tray runners and container feet must sit securely on the grid while air or liquid passes through the openings.
Through-Openings Along a Flat Carrying Run
The 1901B grid lets air and liquid pass through the carrying area. The product rests on the ribs around those openings, so its contact pattern determines the support it receives.
The 4.6 mm connecting pins are a useful identification detail when comparing an installed belt. They should be checked with the module joints and sprocket geometry. A similar-looking closed top is a different carrying surface.
Specifications
| Parameter | Specification |
|---|---|
| Model / profile | Specification: 1901B / flush grid |
| Belt materials | Specification: POM / PP |
| Pin materials | Specification: POM / PP / PA6 |
| Pin diameter | Specification: 4.6 mm / 0.181 in |
| Open area | Specification: 16% |
| Backflex radius | Specification: 25 mm / 0.984 in |
| Belt mass | Specification: 6.5 kg/m² / 1.331 lb/ft² |
| POM temperature range | Specification: −30 to 90 °C / −22 to 194 °F |
| PP temperature range | Specification: −30 to 90 °C / −22 to 194 °F |
Confirm the selected material-and-pin combination for the actual process. Agree the finished width using the module arrangement drawing.
Check the Grid, Joint and Support Bed
Compare product feet with the openings, including the smallest item that will run on the conveyor. Show the support strips beneath the belt where flow is required.
Check return bends against the 25 mm backflex radius. Compare the existing sprocket and pin joints before selecting a replacement, then review the end transfer with the actual product base.
Carry Products While Liquid Drains Away
On a draining conveyor section, openings in the carrying face provide a route beneath supported products. The support bed and liquid collection arrangement must leave that route open.
For an airflow process, the product base may cover part of the grid. Assess the exposed openings and the support available at discharge. Open area describes the belt, rather than the amount of flow that reaches a specific product.
Review Your 1901B Grid Duty
Send the required finished width, assembled length and quantity with a product-base sketch. Add the drive reference and drainage or airflow arrangement for a focused fit review.